"DC3 LS, Fuck Hyundai, now and forever" (eg6)
05/12/2019 at 21:23 • Filed to: None
1
5|
"DC3 LS, Fuck Hyundai, now and forever" (eg6)
05/12/2019 at 21:23 • Filed to: None | 1
| 5 |
Fuck Hyundai, fuck KIA, and fuck all of Korea. Never again.
Of the two bolts that hold the wheel cylinder in, the one closer to the rear of the car, literally cannot be accessed by any tool I own, or at the local autozone. Because of how the the dust cover is shaped a normal fucking wrench literally cannot fit around it. Went to autozone and bought the smallest fucking 1/4 drive socket wrench and 10mm socket, it’s too close to the knuckle for even that to fit over it. Obviously can’t access it from the top because of the wheel cylinder it fastens to the knuckle. And can’t reach it from the rear.
This shit is an absolute fucking joke, I’m seriously considering junking this car, and just doing my summer job and senior year of college without a car. This shit is beyond a fucking joke. I hope the person who approved this desgin and his decendants for 1,000 fucking years are fucking cursed
because this is some bullshit of a higher order than any thing I had to deal with on the god damn Accord from hell
. It’d be one thing if it was a European car, but on an Asian car when the whole fucking point is that it’s suppose to be simple and easy to work on? Flat out inexcusable
, I’ll literally never by another Korean car, so help me god.
jimz
> DC3 LS, Fuck Hyundai, now and forever
05/12/2019 at 21:31 |
|
can you remove the back plate to get at it? I’m willing to bet it’s like that because the wheel cylinder is PIA to the brake/backing plate when it arrives at the assembly plant.
|
DC3 LS, Fuck Hyundai, now and forever
> jimz
05/12/2019 at 21:39 |
|
I’ll double check tomorrow, but I’m not sure
.
|
DC3 LS, Fuck Hyundai, now and forever
> jimz
05/12/2019 at 21:46 |
|
Yeah, doesn’t look like it, although I’ll still check tomorrow.
NojustNo
> DC3 LS, Fuck Hyundai, now and forever
05/16/2019 at 15:16 |
|
Ratc heting wrench fit in there?
|
DC3 LS, Fuck Hyundai, now and forever
> NojustNo
05/16/2019 at 15:35 |
|
Nope, would up using a I joint and extention, still couldn't get it on properly, had to hold the socket in place to keep it from popping off, since it couldn't go on straight.