National holiday today so I had time to develop an affordable suspension lowering solution

". ." (xllx) 05/31/2018 at 09:35 • Filed to: properly fixed

5

11

CalzoneGolem > . . 05/31/2018 at 09:43

0

I love the firewall design.

RamblinRover Luxury-Yacht > CalzoneGolem 05/31/2018 at 09:48

1

I think this is rear suspension and that’s part of this thing being a ute project gone bad.

SilentButNotReallyDeadly...killed by G/O Media > . . 05/31/2018 at 09:55

1

It almost looks 3D printed!

SmugAardvark > . . 05/31/2018 at 10:02

2

Totally legit. I see no conceivable way that either of those two welds could ever fail.

. . > SmugAardvark 05/31/2018 at 10:04

0

I know, right?

PartyPooper2012 > . . 05/31/2018 at 10:31

2

It looks solid, but just for safety, throw one or two strips of duct tape over it.

Future next gen S2000 owner > . . 05/31/2018 at 10:35

2

I know this series is in good fun and I appreciate it but some of these cause me to go into an rage. If the had just turned the upper member 90 degrees, they would get so much less flex. Like wise with the lower vertical piece. They are doing bad fixes incorrectly!

My bird IS the word > . . 05/31/2018 at 11:15

0

I like how they just stopped at two pieces.

M.T. Blake > . . 05/31/2018 at 11:36

0

The same time it took to build that, the owner could have worked and saved up to buy the proper parts!

Rusty Vandura - www.tinyurl.com/keepoppo > . . 05/31/2018 at 11:46

0

At least they didn’t use plumber’s tape and sheet metal screws...

Kiltedpadre > . . 05/31/2018 at 12:43

0

Replace the weld at the side panel with a piano hinge and you could adjust the suspension by changing tension on the top nut.