![]() 04/24/2017 at 09:36 • Filed to: None | ![]() | ![]() |
The seal has gotten too small and falls down frequently. I think that !!!error: Indecipherable SUB-paragraph formatting!!! is the right part but I’m not totally sure. Does it looks like the right part?
![]() 04/24/2017 at 09:38 |
|
Ours does this too.
![]() 04/24/2017 at 09:42 |
|
Yes, that is the right part. Your (badass) MS paint illustration is off though, as it runs under the garnish assembly on the sill.
![]() 04/24/2017 at 09:42 |
|
¯\_()_/¯
Related. My wife has this same issue with the rear doors on her Focus. I’ve replaced both sides and now the passenger side is doing g it AGAIN.
![]() 04/24/2017 at 09:49 |
|
Not a huge deal, but it’s very annoying and makes the car look run down lol
![]() 04/24/2017 at 09:49 |
|
Yeah I know, I thought about drawing it the right way but then I was like, that part of the seal isn’t visible anyway
![]() 04/24/2017 at 09:49 |
|
How long ago did you replace them?
![]() 04/24/2017 at 09:50 |
|
You’ve got the correct part number picked for the body mounted opening seal for an 07-10 Odyssey right front door.
A lot of body door opening weather strips do that. My rear door opening seals are shrinking on my 08 Civic, and I’ve seen it on dozens of other Honda/Toyota products.
![]() 04/24/2017 at 09:53 |
|
stick it back on with sikaflex or something similar.
![]() 04/24/2017 at 10:00 |
|
Are you sure it’s not from tension under mounting, like say where they go under that bottom step-piece that pulls them tight/off the jamb?
![]() 04/24/2017 at 10:01 |
|
I wanna say summer 2015 for the passenger side....
![]() 04/24/2017 at 10:04 |
|
Yeah I am pretty sure because its only been an issue for the past year. Up until then it has been fine...
![]() 04/24/2017 at 10:19 |
|
So they pretty much just get too loose to cling onto it, gotcha. If new ones fail, i’d be silly and probably just glue them in place...
![]() 04/24/2017 at 10:20 |
|
Can you cut the seal under the sill plate and readjust it so there is more slack up top, thus keeping it from pulling down?