"ImmoralMinority" (araimondo)
10/07/2017 at 10:17 • Filed to: None
4
6|
"ImmoralMinority" (araimondo)
10/07/2017 at 10:17 • Filed to: None | 4
| 6 |
I need to wash the Sunchaser, but today my focus is on the Cressida.
I am changing the valve covers, because one is warped and leaking. I have beautiful restored OEM covers and new gaskets.
I have never done this before, and am watching videos over my morning coffee. Any Oppo pointers? One of you must have done this on a Supra with this engine.
pip bip - choose Corrour
> ImmoralMinority
10/07/2017 at 10:20 |
|
take a lot of pics before disassembly and label where the hoses go too.
Duck Duck Grey Duck FTMFW!
> ImmoralMinority
10/07/2017 at 10:25 |
|
If you have the option to, blow compressed air all over the area so you don’t have to worry about any grit dropping into the valvetrain when you pull the covers off.
crowmolly
> ImmoralMinority
10/07/2017 at 11:17 |
|
What are the gaskets made of?
Depending on the material I’ll use some high-tack on the valve cover side to keep the gasket in place.
PS looks like you need to change your brake fluid.
shop-teacher
> ImmoralMinority
10/07/2017 at 11:19 |
|
Be gentle, and tighten those covers down evenly, little by little.
Junkrat aka Rick Sanchez: Fury Road Edition
> crowmolly
10/07/2017 at 12:02 |
|
If it is a car I have to adjust valves on regularly, I will dot the head side with a few dots of chapstick. That way it always comes off in ine piece. I’ve never had a problem with leaking.
notsomethingstructural
> ImmoralMinority
10/07/2017 at 12:07 |
|
Few things - I haven’t done this engine but I’ve done my share of valve cover gaskets.
1. Get the torque specs and sequencing for the bolts. They’re usually on the order of 8-12 ft-lb BUT some are shouldered positive stop bolts and if you’ll shatter the bolt if you don’t, well, stop. No torque specs for those, it’s barely more than finger tight. Sequencing is important too, some want corners first some want corners last.
2. Check that there are no points for RTV. Many manufacturers for their VCG jobs want you to put a bead in the corners or anywhere it isn’t flat.
3. Clean the hell out of both mating surfaces. Scrape the head with a razor blade then either wire brush or *lightly* sand with 220-400 grit paper. Then wipe with wax and grease remover or isopropyl alcohol. Make sure the shit doesn’t fall into the engine, I usually blue tape a little builders paper over the valve train just to be sure.
It’s not likely this will be the difference between whether it leaks at the end or doesn’t, but if it DOES leak people will definitely ask if you did this stuff. So do it for your peace of mind :)