"TheHondaBro" (wwaveform)
04/29/2016 at 18:32 • Filed to: Project simulator
3
1|
"TheHondaBro" (wwaveform)
04/29/2016 at 18:32 • Filed to: Project simulator | 3
| 1 |
This time I can say with certainty that there is only one thing left to do, and that’s to reinforce the shifter stand. I need to cut up a piece of 2x2, paint it then attach it.
After that, I integrate both pieces (seat+G920), screw on the floor piece, and it’s done.
What I did today was to secure the PSU to the frame. I did that by removing the cover and attaching a couple of brackets to it, then to the seat frame.
To keep the screws from shorting the PSU, I covered the heads with electrical tape
I cleaned up the wires underneath, then I cleaned the seat one more time.
In the drivers seat
MM54
> TheHondaBro
04/29/2016 at 19:44 |
|
Very cool!
Progress on my build has hit yet another pause while I work up the motivation to cut the two remaining braces for the “table” and design the shifter holder.