Morning Oppo

Kinja'd!!! "Jayhawk Jake" (jayhawkjake)
10/16/2014 at 08:35 • Filed to: None

Kinja'd!!!1 Kinja'd!!! 11

Something on my car is rattling. I can only hear it when I'm next to something for the sound to reflect off, and it doesn't rattle at idle. This might be difficult to find...

Kinja'd!!!

Then again, it's probably just that damn wideband plug bolt that fell out over the weekend. I'm gonna thread lock the shit out of it


DISCUSSION (11)


Kinja'd!!! Twingo Tamer - About to descend into project car hell. > Jayhawk Jake
10/16/2014 at 08:39

Kinja'd!!!3

Most common cause of rattles on cars now is heat shields, check them first.


Kinja'd!!! CalzoneGolem > Jayhawk Jake
10/16/2014 at 08:44

Kinja'd!!!0

Once I had a rattle I couldn't find. It was a wrench that someone lost in the engine bay and I only found it by chance.


Kinja'd!!! Steve in Manhattan > Twingo Tamer - About to descend into project car hell.
10/16/2014 at 08:50

Kinja'd!!!0

My first thought ... especially buzzing sounds.


Kinja'd!!! Nick, Drives a Cobalt LT > Jayhawk Jake
10/16/2014 at 08:53

Kinja'd!!!0

could be a heatshieldnto

if its auto just power brake it and see if you can isolate it to somewhere in the exhaust


Kinja'd!!! Twingo Tamer - About to descend into project car hell. > Steve in Manhattan
10/16/2014 at 08:54

Kinja'd!!!0

Yep, they slowly work themselves loose or get bent/ cracked all the time.


Kinja'd!!! Steve in Manhattan > Twingo Tamer - About to descend into project car hell.
10/16/2014 at 08:55

Kinja'd!!!0

Tack welding is the cure.


Kinja'd!!! Twingo Tamer - About to descend into project car hell. > Steve in Manhattan
10/16/2014 at 08:57

Kinja'd!!!0

I just add bigger washers and loctite when I refit them, since I don't have any welding gear.


Kinja'd!!! twochevrons > Twingo Tamer - About to descend into project car hell.
10/16/2014 at 09:16

Kinja'd!!!0

Or, if you let them go for long enough, they eventually fall off. No more rattles!

I kid, I kid. Apparently the heat shield on my Volvo is crucial, in order to prevent heat soak from the turbocharger from cooking the brake fluid in the lines that run just above it on the firewall. Wonder which genius thought of that one...


Kinja'd!!! Twingo Tamer - About to descend into project car hell. > twochevrons
10/16/2014 at 09:23

Kinja'd!!!0

I recently cut one off my stepdads beater micra because I couldnt be bothered to fix it. That was only for one small bit of the exhaust nowhere near anything else like brake lines and stuff. Strange having the turbo near the brake lines though, mine are attached to the bulkhead and the turbo is between the engine and radiator.


Kinja'd!!! twochevrons > Twingo Tamer - About to descend into project car hell.
10/16/2014 at 09:30

Kinja'd!!!0

Yeah, Volvo's transverse layout has the exhaust side of the engine facing the rear of the car, so the turbo is low down, close to the firewall. Definitely gets toasty back there. The ABS computer lives in the vicinity, too, and they don't take too kindly to the heat, either.


Kinja'd!!! Twingo Tamer - About to descend into project car hell. > twochevrons
10/16/2014 at 09:41

Kinja'd!!!0

I notice that renault do the same thing, my mams renault laguna gets a very spongy brake pedal after a long run becausr of the heat. Becomes quite sketchy when towing actually, people reccomend putting in better brake fluid and that somewhat cures it.