by "Brickman" (legomaniacman)
Published 06/30/2017 at 11:47
by "Brickman" (legomaniacman)
Published 06/30/2017 at 11:47
No Tags
STARS: 2
A couple of days ago I was about to remove the fuel and return the fuel pump I just put in. I decided to check to see if I had a good ground on the wiring harness to the fuel pump and it did. Checked the relay and fuses. Tested them to see if it was good and it was. Turned the engine over and it started and stayed running!
I dont know if it needed to sit for a few days to remove air from injector lines or maybe I did something, but now I have my ol egg mobile back! Took it for a spin around the block about 5 times and no problems. Starts right up, good acceleration, etc.
The A/C compressor is starting to break down, but I know how to fix that.
"Manwich - now Keto-Friendly" (manwich)
06/30/2017 at 11:55, STARS: 1
Now that that’s done, it’s time for a Hemi swap!!!
"merged-5876237249235911857-hrw8uc" (merged-5876237249235911857-hrw8uc)
06/30/2017 at 13:10, STARS: 1
If you unplugged and replugged the connections and relays, maybe you just had corrosion on the contacts that was cleaned up following the procedure. Good news nonetheless.
"Brickman" (legomaniacman)
06/30/2017 at 15:20, STARS: 0
Thats what I hope. Or some electrical gremlin running around.
"Long-Voyager" (long-voyager)
03/29/2018 at 07:28, STARS: 1
SRT4 works well in these, direct bolt in:
