by "Alex B" (alexb420)
Published 04/24/2017 at 09:36
by "Alex B" (alexb420)
Published 04/24/2017 at 09:36
No Tags
STARS: 0
The seal has gotten too small and falls down frequently. I think that this is the right part but I’m not totally sure. Does it looks like the right part?
"Smallbear wants a modern Syclone, local Maple Leafs spammer" (smallbear94)
04/24/2017 at 09:38, STARS: 0
Ours does this too.
"Tekamul" (tekamulburner)
04/24/2017 at 09:42, STARS: 1
Yes, that is the right part. Your (badass) MS paint illustration is off though, as it runs under the garnish assembly on the sill.
"V8Demon - Prefers Autos for drag racing. Fite me!" (v8demon)
04/24/2017 at 09:42, STARS: 0
¯\_()_/¯
Related. My wife has this same issue with the rear doors on her Focus. I’ve replaced both sides and now the passenger side is doing g it AGAIN.
"Alex B" (alexb420)
04/24/2017 at 09:49, STARS: 1
Not a huge deal, but it’s very annoying and makes the car look run down lol
"Alex B" (alexb420)
04/24/2017 at 09:49, STARS: 0
Yeah I know, I thought about drawing it the right way but then I was like, that part of the seal isn’t visible anyway
"Alex B" (alexb420)
04/24/2017 at 09:49, STARS: 0
How long ago did you replace them?
"Rust and Dust - Oppositelock Forever" (rustanddust)
04/24/2017 at 09:50, STARS: 0
You’ve got the correct part number picked for the body mounted opening seal for an 07-10 Odyssey right front door.
A lot of body door opening weather strips do that. My rear door opening seals are shrinking on my 08 Civic, and I’ve seen it on dozens of other Honda/Toyota products.
"pip bip - choose Corrour" (hhgttg69)
04/24/2017 at 09:53, STARS: 0
stick it back on with sikaflex or something similar.
"Echo51" (echo2047)
04/24/2017 at 10:00, STARS: 0
Are you sure it’s not from tension under mounting, like say where they go under that bottom step-piece that pulls them tight/off the jamb?
"V8Demon - Prefers Autos for drag racing. Fite me!" (v8demon)
04/24/2017 at 10:01, STARS: 0
I wanna say summer 2015 for the passenger side....
"Alex B" (alexb420)
04/24/2017 at 10:04, STARS: 0
Yeah I am pretty sure because its only been an issue for the past year. Up until then it has been fine...
"Echo51" (echo2047)
04/24/2017 at 10:19, STARS: 0
So they pretty much just get too loose to cling onto it, gotcha. If new ones fail, i’d be silly and probably just glue them in place...
"merged-5876237249235911857-hrw8uc" (merged-5876237249235911857-hrw8uc)
04/24/2017 at 10:20, STARS: 0
Can you cut the seal under the sill plate and readjust it so there is more slack up top, thus keeping it from pulling down?