by "That Bastard Kurtis - An Attempt to Standardize My Username Across Platforms" (thatbastardkurtis5)
Published 03/24/2017 at 20:36
by "That Bastard Kurtis - An Attempt to Standardize My Username Across Platforms" (thatbastardkurtis5)
Published 03/24/2017 at 20:36
No Tags
STARS: 6
I got out of work a little early today, so I made a few measurements and headed to Lowes.
One piece of 4x8 plywood, Lowes gives you up to 5 cuts for free which is pretty good. So the top piece is 48x41 and it’s set 14 inches high to clear the toolboxes, which it does by about half an inch.
Tomorrow I need to cut the pieces to support the sides. It won’t be a full box, because of the wheel wells, and I’ll be left with some little side compartments...I don’t know if I’ll hinge in some covers or not, but that’s not high on the list of priorities. Screwing it together and carpeting it is basically all that’s left.
"OPPOsaurus WRX" (opposaurus)
03/24/2017 at 20:50, STARS: 1
When I had an Explorer Sport Trac I could fit plywood and sheet rock in the back but not between the wheels wells to lay flat so I made a stand that went behind the cab and on the tailgate so I could support the sheetrock on those and the wheel wells.
"XJDano" (xjdano)
03/24/2017 at 21:05, STARS: 1
I need to do this fory middle seal like we talked about eariler. Same concept, smaller scale.
"404 - User No Longer Available" (toni-cipriani)
03/24/2017 at 21:47, STARS: 1
Should paint and polish that wood.
"That Bastard Kurtis - An Attempt to Standardize My Username Across Platforms" (thatbastardkurtis5)
03/24/2017 at 22:25, STARS: 0
Ha. My plywood is maybe not quite that nice.